1. The production expectation of the mould, what kind of raw materials are used in this decision and how much is the price.
2. The size and shape of the product are simple, the resolution is high, and the corresponding structure of the plastic mold is directly related to the cost of the plastic mold.
3. The product size, appearance requirements, fine requirements, appearance requirements and processing cost are different.
4. The number of holes on the mold is required, that is, to change a mold and produce several products, that is, one or more. Generally, this is not the only product that is too large.
Generally speaking, the production cost of plastic mold is 6-10 times of its data cost. The specific amount depends on the degree of disorder of the plastic mold. The structure is simple and the requirements are not high. The plastic mold uses general raw materials, the product is less than 10cm, and the cost of two hole mold is less than 20000. It's hard to say the details, it's all about the product. If there is a detailed product drawing, the relatively close cost can be calculated, but the quotation of each plastic mold manufacturer will vary greatly, because each plastic mold manufacturer has different requirements for profit point.
Why is it so expensive to open plastic mould?
This is mainly due to the disordered structure, many processing procedures, high labor cost, and the material price of injection mold is not cheap, so the cost of plastic mold is naturally not low.
The above information is collected and released by our Shandong Aluminum Alloy Die Casting Factory. We hope that you will like our website: http://www.ok9868.com!